Blizzard-lighting Motif Sketch (Rev C) Manual de usuario Pagina 11

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 10
Page 11
Motif Sketch™ Manual Rev. C Copyright (c) 2013 Blizzard Lighting, LLC
Blackout
The blackout button on the remote control <B> will turn off the LEDs, regard-
less of what mode you are currently running. Push the blackout <B> button
again to return to its previous mode.
Built-in Programs
To run one of the six built-in programs, press the <SPR> button. You will see
the LEDs ash yellow, prompting you to then select a program number from
buttons <2-7> on the numeric keys. You can also access static color mode
from here by pressing button <1>. (see the static color table, page 10)
Built-in programs
Button 2 Button 3 Button 4
7-Color Fade 3-Color Fade Fantasy Color Fade
Button 5 Button 6 Button 7
7-Color Snap 3-Color Snap Various Color Snap
Now you can adjust the program speed and ash (strobe) by pushing their
corresponding buttons: <SP> button for speed, and the <FL> button for
ash. Then use the <+/-> buttons to adjust the rate. The <+> button will
increase the speed, and <-> button will decrease the speed.
Auto Mode
In auto mode, the xture will run the built-in programs 2-7 in sequence. Press
the <AR> button to start auto mode. Speed and ash setting will be inherited
from your settings in program mode.
Manual Color Adjustment
This allows you to adjust the color balance of the xture. These settings are
global, they will effect all modes.
To adjust the 16 intensity levels of red, green, or blue (0% - 100%), press
either the
<R>, <G>, or <B> buttons on the remote control.
Then use the
<+/-> buttons to adjust the intensity. The <+> button will increase the
intensity, and <-> button will decrease the intensity.
Slave Mode
To set the xture to run in slave mode, push the <SL> button. The xture is
now in slave mode. Tip: If you want the xture to be black without DMX, set
the xture to slave mode.
Restore Factory Settings
To restore the Motif Sketch™ back to its factory installed settings, rst press
the blackout button <BL> to turn off the LEDs. Then, press the numeric keys
<9>, <8>, and <7> in that order.
Vista de pagina 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios