Blizzard-lighting Motif Sketch (Rev C) Manual de usuario descargar pdf (Pagina 10)

Page 10

Setting the DMX Address

1.) To set the starting DMX address, push the

<S> button. You’ll see the LEDs ash 3 times in a

sequence of colors that indicate the currently set

DMX address. For example, if the DMX address is

currently 001, the ashes would be white (zero)/

white (zero)/ red(one). (See static color table)

2.) Enter a 3-digit DMX address: 001-512.

3.) Now you’ll see the LEDs ash 3 times per digit

you enter, and notably, they will ash the assigned

static color that corresponds to that digit. For

example, setting the xture to the DMX address of

010, the ashes would be white (zero)/ red (one)/

white (zero). (See static color table)

Static Colors

To use xture in static color mode, press either the

<R>, <G>, or <B> buttons, and then one of the numeric buttons (0-9). The color

table below shows the static color for each number.

Static color table

Button 0 Button 1 Button 2 Button 3 Button 4

White Red Orange Light Yellow Green

Button 5 Button 6 Button 7 Button 8 Button 9

Cyan Blue Purple Pink Yellow

DMX Mode

The Motif Sketch™ will automatically recognizes a DMX signal when connected to a

controller, and will function in 3-channel RGB color mixing mode. If the DMX signal is

lost, the xture will revert to its previously set mode.

You can use the remote control while in DMX mode to switch to any other mode.

Then to return to DMX mode, press the <D> button.

3-channel DMX mode

Channel Channel Value What it does...

1 000 <-> 255 Red Intensity (0 <--> 100%)

2 000 <-> 255 Green Intensity (0 <--> 100%)

3 000 <-> 255 Blue Intensity (0 <--> 100%)

4. OPERATING ADJUSTMENTS

The Remote Control

All the goodies and different modes possible with the Motif Sketch™ are accessed by

using the IR remote control (sold separately).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Blizzard-lighting Motif Sketch (Rev C) Manual de usuario Pagina 10